colb's latest activity
-
colb replied to the thread 2.8 Z3 1998.https://www.rbmhampshire.co.uk/ Good reputation and not far from you. -
colb replied to the thread Sorry - Really bad picture - But, what the . ..Not seen that about
-
colb replied to the thread Oil film inside Inlet Manifold.Rudyrov is correct maybe its time to clean all the PCV hoses, they do get gunked up over the years, I actually renewed all of mine, bit...
-
Actually did a job on the car today …nothing much but it’s been bugging me every time I go in the garage…. fitted this … It came off...
-
I finally got it fitted. I took it off the ICV port and fitted it to the TB first, and then did the ICV again. Kicking myself that I...
-
colb replied to the thread Is this a new O2 sensor?.Tube not tune
-
colb replied to the thread Is this a new O2 sensor?.Make sure the main boot to throttle body is in right orientation there is a shaped cut out the boot flap fits into on the throttle body...
-
colb replied to the thread Is this a new O2 sensor?.Split boot is almost certainly the major cause of your issue it's imperative that the whole intake and. Vacuum system is sealed on these...
-
colb replied to the thread Is this a new O2 sensor?.Good find on the idle control valve, cleaning that may well sort the idle issue. If the intake boot had a hole or split that would have...
-
@colb visited this week and used his compressor and schutz gun to get the waxoyl into the cavities. Then we got the sills on. Car...
-
colb replied to the thread E89 Air Filter change.If you want to take the box out undo the top screws and pull the box upwards it's held in at the bottom in a rubber grommet.
-
colb replied to the thread E89 Air Filter change.TIS Removal instructions
-
colb replied to the thread Is this a new O2 sensor?.Only specific Maf cleaner spray should be used on it, nothing else otherwise you will kill it. My experience of Maf's are they either...
